SENSEO® HD7820 Manuel d'utilisateur télécharger pdf (Page 18)

Troubleshooting

If you have a problem, you may nd the solution in the table below. If

the table does not provide the solution to your problem or if you have a

question, see chapter ‘Guarantee & service’.

Problem Solution

The indicator light continues

to ash slowly.

You have not yet ushed the coffee machine (see chapter ‘Preparing the

machine for use’).

You have used the SENSEO

coffee machine at an altitude higher than

2200 metres above sea level. This has caused the water in the machine

to start boiling before it has reached the required temperature, which

prevents the machine from functioning properly. Switch the machine off

and no longer use it at altitudes higher than 2200 metres above sea level.

The SENSEO

coffee

machine does not produce

coffee when used for the

rst time.

You have not yet ushed the coffee machine. When you use the machine

for the rst time, you have to ush it before you start brewing coffee (see

chapter ‘Preparing the machine for use’).

The indicator light continues

to ash rapidly.

Make sure that:

the water reservoir has been properly placed;

there is enough water in the water reservoir (i.e. above the q MIN level

if you want to brew 1 cup);

the ambient temperature is not lower than 10 °C. If it is, the machine will

not function properly.

Type HD7824 only: the 2-

cup button qq cannot be

operated.

Make sure that there is enough water in the water reservoir for brewing

2 cups of coffee. If the light ring around the 2-cup button qq is out,

there is not enough water in the water reservoir for brewing 2 cups.

Water leaks from the coffee

machine.

Make sure that:

the lid is properly closed (the lever must be properly locked);

the water reservoir has not been lled beyond the MAX level;

the sieve in the centre of the pod holder is not clogged. If it is, unclog the

sieve by holding the pod holder under a running tap. If necessary, you can

use a washing-up brush or a pin to unclog the sieve;

the coffee pod has been put properly in the centre of the pod holder;

the sealing ring has not got stuck under the edge of the water distribution

disc (see gure 1 at the beginning of these instructions for use).

the water drops on the worktop are not the result of placing or

removing the water reservoir or removing used coffee pods.

you do not remove the water reservoir when the coffee machine is

heating up. This may cause water that normally ends up in the water

reservoir to leak out of the machine.

ENGLISH18

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 81 82

Commentaires sur ces manuels

Pas de commentaire

SENSEO® HD7820 Manuel d'utilisateur Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Cafetières SENSEO® HD7820